2005-2008 Yaris · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built from Nov 2005


1. INSTALL SHIFT STROKE SENSOR

C114017E01
  1. Apply MP grease to a new O-ring.

  1. Install the new O-ring onto the stroke sensor.

  1. Set the stroke senor so that the sensor side and the actuator side sensor arms are in the positions shown in the illustration.

  1. C112891
    Turn the stroke sensor clockwise and fix it with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }

  1. Connect the shift stroke sensor connector.

  1. C127599
    Install the wire harness bracket onto the transaxle with the bolt.

    Torque:
    13 N*m{ 131 kgf*cm , 9.5 ft.*lbf }


2. INSTALL BATTERY CARRIER (for 1KR-FE)

C106985
  1. Install the battery carrier with the 4 bolts.

    Torque:
    17 N*m{ 175 kgf*cm , 13 ft.*lbf }


3. INSTALL BATTERY CARRIER (for 2SZ-FE)

C106370
  1. Install the battery carrier with the 5 bolts.

    Torque:
    17 N*m{ 175 kgf*cm , 13 ft.*lbf }


4. INSTALL BATTERY TRAY

5. INSTALL BATTERY

6. INSTALL BATTERY HOLD DOWN CLAMP

7. INSTALL AIR CLEANER INLET NO.1 (for 2SZ-FE)

C127624
  1. Install the air cleaner inlet No. 1.


8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


9. INITIALIZATION OF MULTI-MODE MANUAL TRANSMISSION ECU
(Click here)

10. LEARNING OF MULTI-MODE MANUAL TRANSMISSION SYSTEM
(Click here)

11. SYNCHRONIZATION POSITION CALIBRATION
(Click here)
← INSPECTION (from Nov 2005)COMPONENTS (from Nov 2005) →