2005-2008 Yaris · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. REMOVE REAR GENERATOR END COVER

A128395
  1. Remove the 2 terminal covers by turning them counterclockwise.

  1. A128396
    Using a 15 mm socket wrench, remove the 2 nuts from the rear generator end cover.

  1. Remove the screw, then remove the rear generator end cover.


2. REMOVE REGULATOR SUB-ASSEMBLY GENERATOR WITH BRUSH

A128397
  1. Remove the 3 screws, then remove the regulator sub-assembly generator with brush.


3. REMOVE STATOR SUB-ASSEMBLY GENERATOR WITH RECTIFIER

A128398
  1. Remove the 4 bolts.

  1. Remove the bolt and cord clip.

  1. A128399
    Using a screwdriver with its tip wrapped in tape, pry out the stator sub-assembly generator with rectifier.


4. REMOVE BEARING SET GENERATOR

A128400

5. REMOVE PULLEY SET GENERATOR
  1. Clamp the swivel arm in a vise.

    NOTICE:
    Do not clamp the generator rotor in a vise.

  1. A128401E01
    Using a socket 24 AF and an 8 mm bi-hexagon wrench, remove the nut and spring washer, then detach the pulley.


6. REMOVE GENERATOR ROTOR ASSEMBLY

A128402
  1. Using a press, press out the generator rotor assembly and spacer ring.

← REMOVAL (from Nov 2005)INSPECTION (from Nov 2005) →