2005-2008 Yaris · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSTALL GENERATOR ROTOR ASSEMBLY

A128407
  1. Using SST and a press, press in the generator rotor assembly.

    SST
    09285-76010  

    NOTICE:
    Avoid misalignment during pressing.


2. INSTALL PULLEY SET GENERATOR

A128408
  1. Install the spacer ring.

  1. A128401E01
    Using a socket 24 AF and an 8 mm bi-hexagon wrench, install the pulley with the spring washer and nut.

    Torque:
    65 N*m{ 663 kgf*cm , 48 ft.*lbf }


3. INSTALL BEARING SET GENERATOR

A128410E01
  1. Align the 3 cutouts of the stator sub-assembly generator with rectifier with the protrusions of the bearing set generator.


4. INSTALL STATOR SUB-ASSEMBLY GENERATOR WITH RECTIFIER

A128398
  1. Align the key of the drive end frame with the keyway of the stator sub-assembly generator with rectifier.

  1. Install the stator generator with rectifier with the 4 bolts.

    Torque:
    4.3 N*m{ 44 kgf*cm , 38 in.*lbf }

  1. Install the cord clip with the bolt.

    Torque:
    6.5 N*m{ 66 kgf*cm , 58 in.*lbf }


5. INSTALL REGULATOR SUB-ASSEMBLY GENERATOR WITH BRUSH

A128411
  1. Attach the brushes and terminals to the rectifier end frame of the regulator generator with brush.

  1. Install the regulator generator with brush with the 3 screws.

    HINT:
    Install screw B into the position shown in the illustration.


    A128412E01

    Torque:
    2.5 N*m{ 25 kgf*cm , 22 in.*lbf } for screw A
    1.2 N*m{ 12 kgf*cm , 11 in.*lbf } for screw B


6. INSTALL REAR GENERATOR END COVER

A128396E01
  1. Install the generator rear end cover with the 2 nuts and screw.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf } for nut A
    12 N*m{ 122 kgf*cm , 9 ft.*lbf } for nut B
    2.8 N*m{ 29 kgf*cm , 25 in.*lbf } for screw

  1. A128395
    Install the 2 terminal covers by turning them clockwise.

← INSPECTION (from Nov 2005)INSTALLATION (from Nov 2005) →