2005-2008 Yaris · Service Manual TRANSMISSION

P0715 Input / Turbine Speed Sensor Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

The transmission revolution sensor is mounted on the transmission. The transmission control ECU calculates the transmission input shaft speed using the sensor. When the input shaft rotates, the sensor generates a pulse signal and sends the signal to the transmission control ECU. The ECU calculates the input shaft speed based on the signal. If the input shaft speed falls below a threshold despite the vehicle running, the ECU interprets this as a malfunction in the transmission revolution sensor circuit. The ECU sets the DTC and illuminates the multi-mode manual transmission warning light.
DTC No.
DTC Detection Conditions
Trouble Areas
P0715
The transmission control ECU detects the following conditions simultaneously:
(1 trip detection logic)
  1. Vehicle speed is 11 km/h (6.8 mph) or more
  2. Transmission revolution speed is 175 rpm or less for 4 seconds
  1. Open or short in transmission revolution sensor circuit
  2. Transmission revolution sensor
  3. Transmission control ECU

WIRING DIAGRAM

C110751E02

INSPECTION PROCEDURE


1. CHECK SENSOR INSTALLATION
D032449E02
  1. Check the transmission revolution sensor installation.

    OK:
    Sensor is installed correctly.



NG
SECURELY REINSTALL SENSOR
OK


2. INSPECT TRANSMISSION REVOLUTION SENSOR
C111591
  1. Disconnect the transmission revolution sensor connector.

  1. Measure the resistance between the terminals of the transmission revolution sensor connector.

    Standard resistance:
    Tester Connections
    Specified Conditions
    1 - 2
    560 to 680 Ω at 20°C (68°F)

  1. Reconnect the transmission revolution sensor connector.



NG
REPLACE TRANSMISSION REVOLUTION SENSOR
OK


3. CHECK HARNESS AND CONNECTOR (TRANSMISSION REVOLUTION SENSOR - TRANSMISSION CONTROL ECU)
C112715E06
  1. Disconnect the transmission control ECU connector.

  1. Measure the resistance between the terminals of the ECU connector.

    Standard resistance:
    Tester Connections
    Specified Conditions
    NIP+ (A38-16) - NIP- (A38-15)
    560 to 680 Ω at 20°C (68°F)

  1. Reconnect the transmission control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSMISSION CONTROL ECU ASSEMBLY


← P0703 Brake Switch "B" Circuit (from Nov 2005)P0725 Engine Speed Input Circuit (from Nov 2005) →