P1875 Buzzer Malfunction
Diagnostic trouble codes · Vehicles built from Nov 2005
DESCRIPTION
The buzzer inside the transmission control ECU sounds an alarm when the shift lever is moved into reverse or is mis-operated. This DTC is detected and output when power is not supplied to the buzzer built into the transmission control ECU.- HINT:
- In addition, the buzzer sounds when one of the following conditions is met:
- When the transmission control ECU performs the shift rejection to prevent the engine over revving.
- When the vehicle is stationary and the transmission control ECU operates the shift retry function.
- When the transmission control ECU judges the clutch overheat.
- When the transmission control ECU performs the shift rejection to prevent the engine over revving.
| DTC No. |
DTC Detection Conditions |
Trouble Areas |
| P1875 |
The transmission control ECU detects the following conditions simultaneously: (1 trip detection logic)
|
|
INSPECTION PROCEDURE
| 1. INSPECT TRANSMISSION CONTROL ECU ASSEMBLY (BUZZER OPERATION) |
Turn the ignition switch on (IG).
Shift the lever into reverse.
Check the buzzer operation.
- OK:
- The buzzer sounds.
|
|
||||
| OK | |
| 2. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P1875) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Select the following menu items: Powertrain / Multi-Mode M/T / DTC.
Read DTCs.
- Result:
Display (DTC Output)
Proceed To
P1875
A
P1875 and other DTCs
B
|
|
||||
| A | ||
| ||
