2005-2008 Yaris · Service Manual STEERING

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jan 2006

Versions by build date: Aug 2005 – Dec 2005 from Jan 2006

Perform troubleshooting according to the following flowchart.

HINT:
For further details, see the page given.
The intelligent tester can be used at steps 3, 4, 7, 10 and 13.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
      NEXT

      3.CHECK DTC AND FREEZE FRAME DATA
      1. Record DTCs and freeze frame data (Click here ).

      NEXT

      4.CLEAR DTC AND FREEZE FRAME DATA

        HINT:
        Clear DTC and FREEZE FRAME DATA (Click here ).

      NEXT

      5.PROBLEM SYMPTOM CONFIRMATION

        .

        .
        6.SYMPTOM SIMULATION
          NEXT

          7.CHECK DTC
          1. Recheck for DTCs (Click here ).

          2. HINT:
            1. Refer to the diagnostic trouble code chart when any DTCs are output.
            2. When any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.
            3. When communication to the power steering ECU is not established through the intelligent tester, inspect terminals SIL of the DLC3 and the power steering ECU, and the IG circuit of the power steering ECU.


          .

          .
          8.PROBLEM SYMPTOMS TABLE

            HINT:
            Refer to PROBLEM SYMPTOMS TABLE.

          NEXT

          9.DTC CHART

            HINT:
            Refer to DIAGNOSTIC TROUBLE CODE CHART (Click here ).

          NEXT

          10.CIRCUIT INSPECTION
            NEXT

            11.PROBLEM IDENTIFICATION
              NEXT

              12.REPAIR OR REPLACE
                NEXT

                13.CONFIRMATION TEST
                  NEXT

                  ← HOW TO PROCEED WITH TROUBLESHOOTING (Aug 2005 – Dec 2005)CALIBRATION (from Aug 2005) →