2005-2008 Yaris · Service Manual STEERING

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from Jan 2006

Versions by build date: Aug 2005 – Dec 2005 from Jan 2006


CHECK DTC

  1. A107926E18
    C141211E01
    When using an intelligent tester;

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG) and turn the tester on.

    3. Read the DTCs by following the prompts on the intelligent tester.

      HINT:
      Refer to the intelligent tester operator's manual for further details.

  2. F100115E02
    When not using an intelligent tester;

    1. Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

      SST
      09843-18040  

    2. Turn the ignition switch on (IG).

    3. F040045E02
      Read and write down any DTCs indicated by the P/S warning light on the combination meter. Refer to the chart on the left for examples of a normal code and DTCs 21 and 22.

      HINT:
      1. If the P/S warning light does not blink to display any DTCs set or the normal code, inspect the circuit shown in the table below.
        Trouble Area
        See Page
        EPS warning light circuit
        Click here
      2. If two or more malfunctions are detected simultaneously, DTCs will be displayed in ascending numerical order.

    4. Refer to the Diagnostic Trouble Code Chart (Click here ) for DTC information.


CLEAR DTC
  1. When using an intelligent tester;

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG) and turn the tester on.

    3. Clear the DTCs by following the prompts on the intelligent tester.

    4. Turn the ignition switch off.

    5. Disconnect the intelligent tester from the DLC3.

  2. F100115E29
    When not using an intelligent tester;

    1. Using SST, connect terminals 12 (TS) and 4 (CG) of the DLC3.

      SST
      09843-18040  

    2. Turn the ignition switch on (IG).

    3. Disconnect the SST check wire from terminal 4 (CG) and reconnect it, and repeat this procedure 4 times or more within 8 seconds.

    4. Check that the P/S warning light blinks a code to indicate normality.

    5. Turn the ignition switch off.

    6. Remove the SST from the DLC3.

← DTC CHECK / CLEAR (Aug 2005 – Dec 2005)FAIL-SAFE CHART (Aug 2005 – Dec 2005) →