INSTALLATION
Removal / installation · Vehicles built from Nov 2005
| 1. INSTALL YAW RATE AND DECELERATION SENSOR |
![]() ![]() |
Connect the yaw rate and deceleration sensor connector.
Install the yaw rate and deceleration sensor with the 2 bolts.
- Torque:
- 8.5 N*m{ 87 kgf*cm , 75 in.*lbf }
| 2. INSTALL CONSOLE BOX REAR COVER |
![]() ![]() |
Engage the 8 claws to install the console box rear cover.
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- Torque:
- 5.4 N*m{ 55 kgf*cm , 48 in.*lbf }
| 4. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION |
| 5. CHECK VSC SENSOR SIGNAL |



