2005-2008 Yaris · Service Manual ENGINE

REPLACEMENT

Removal / installation · Vehicles built from Aug 2005


1. REMOVE VALVE GUIDE BUSH
  1. Gradually heat the cylinder head to 80 to 100°C (176 to 212°F).

  1. Place the cylinder head on a wood block.

  1. A104202
    Using SST, tap out the valve guide bush.
    SST
    09201-87203  


2. INSTALL VALVE GUIDE BUSH
  1. Using a caliper gauge, measure the bush bore diameter of the cylinder head.

    Bush bore diameter:
    9.685 to 9.706 mm (0.38130 to 0.38213 in.)

    If the diameter of the cylinder head is greater than 9.706 mm (0.38213 in.), machine the bush bore to the dimension of 9.735 to 9.756 mm (0.38327 to 0.38409 in.).

    Valve guide bush diameter:
    Item
    Diameter
    Standard
    9.727 to 9.738 mm (0.38339 to 0.38295 in.)
    O/S 0.05
    9.777 to 9.788 mm (0.38492 to 0.38535 in.)

  1. Gradually heat the cylinder head to 80 to 100°C (176 to 212°F).

  1. Place the cylinder head on a wooden block.

  1. A104218E01
    Using SST, tap in a new valve guide bush to the specified protrusion height.
    SST
    09201-87203  

    Protrusion height:
    9.8 to 10.4 mm (0.38583 to 0.40945 in.)

  1. Using a sharp reamer, ream the valve guide bush to the standard specified clearance between the valve guide bush and valve stem.

    Standard oil clearance:
    0.025 to 0.060 mm (0.00098 to 0.00236 in.)

← INSPECTION (from Aug 2005)REASSEMBLY (from Aug 2005) →