VC Output Circuit
Circuit diagnosis · Vehicles built from Nov 2005
DESCRIPTION
The ECM constantly generates 5 V power from the battery voltages supplied to the +B (BATT) terminal to operate the microprocessor. The ECM also provides this power to the sensors through the VC output circuit.

When the VC circuit is short-circuited, the microprocessor in the ECM and sensors that are supplied with power through the VC circuit are inactivated because the power is not supplied from the VC circuit. Under this condition, the system does not start up and the MIL does not illuminate even if the system malfunctions.
- HINT:
- Under normal conditions, the MIL is illuminated for several seconds when the ignition switch is first turned on (IG). The MIL goes off when the engine is started.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK MIL |
Check that Malfunction Indicator Lamp (MIL) lights up when turning the ignition switch on (IG).
- OK:
- MIL lights up
|
|
||||
| NG | |
| 2. CHECK CONNECTION BETWEEN INTELLIGENT TESTER AND ECM |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester on.
Check the communication between the tester and ECM.
- Result:
Result
Proceed To
Communication is possible
A
Communication is not possible
B
|
|
||||
| B | |
| 3. CHECK MIL (THROTTLE POSITION SENSOR) |
Disconnect the C17 throttle body connector.
Turn the ignition switch on (IG).
Check the MIL.
- Result:
Result
Proceed To
MIL illuminates
A
MIL does not illuminate
B
Reconnect the throttle body connector.
|
|
||||
| B | |
| 4. CHECK MIL (ACCELERATOR PEDAL POSITION SENSOR) |
Disconnect the A20 accelerator pedal position sensor connector.
Turn the ignition switch on (IG).
Check the MIL.
- Result:
Result
Proceed To
MIL illuminates
A
MIL does not illuminate
B
Reconnect the accelerator pedal position sensor connector.
|
|
||||
| B | |
| 5. CHECK HARNESS AND CONNECTOR |
![]() ![]() |
Disconnect the C17 throttle body connector.
Disconnect the A20 accelerator pedal position sensor connector.
Disconnect the A21 and C20 ECM connectors.
Check the resistance.
- Standard resistance (Check for short):
Tester Connections
Specified Conditions
VCTA (C20-67) - Body ground
10 kΩ or higher
VCPA (A21-57) - Body ground
VCP2 (A21-58) - Body ground
Reconnect the throttle body connector.
Reconnect the accelerator pedal position sensor connector.
Reconnect the ECM connectors.
|
|
||||
| OK | ||
| ||

