Illumination Circuit
Circuit diagnosis · Vehicles built from Aug 2005
DESCRIPTION
The main body ECU receives information regarding the door courtesy switch, door lock position switch and turns on the room light assembly accordingly.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT FUSE (DOME) |
Remove the DOME fuse from the engine room relay block.
Measure the resistance.
- Standard resistance:
- Below 1Ω
Reinstall the DOME fuse.
|
|
||||
| OK | |
| 2. INSPECT ROOM LIGHT ASSEMBLY |
Inspect room light assembly.

Remove the room light assembly.
Measure the resistance.
- Standard resistance:
Tester connection
Switch operation
Specified resistance
1 - 2
1 - 3
OFF
10 kΩor higher
1 - 2
DOOR
Below 1Ω
1 - 3
ON
Below 1Ω
Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 2, then check that the light comes on when the switch is in the DOOR position.
- OK:
- Light comes on.
Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 3, then check that the light comes on when the switch is in the ON position.
- OK:
- Light comes on.
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (BATTERY - ROOM LIGHT ASSEMBLY AND MAIN BODY ECU) |
Disconnect the 4K main body ECU connector.

Measure the voltage.
- Standard voltage:
Tester Connection
Condition
Specified Condition
4K-2 (ILE) - Body ground
Room light switch is in the DOOR position
10 to 14 V
4K-1 (GND1)- Body ground
Room light switch is in the ON position
10 to 14 V
Reconnect the main body ECU connector.
|
|
||||
| OK | ||
| ||
