2005-2008 Yaris · Service Manual ENGINE

INITIALIZATION

Troubleshooting · Vehicles built from Aug 2005

HINT:
Input the learning value of the throttle position sensor using an intelligent tester after the following operation:
  1. ECM replacement.
  2. Throttle body assembly replacement.


PERFORM ELECTRONIC THROTTLE LEARNING
  1. Turn the ignition switch off.

  2. Connect the intelligent tester to the DLC3.

  3. Turn the ignition switch on (IG) and turn the tester ON.

  4. Clear the DTCs (Click here).

  5. A113693E01
    Select the following menu items: Powertrain / Engine and ECT / Utility / Electric Throttle Learning.

  6. Confirm that the initial conditions displayed on the tester screen are satisfied and press NEXT.

  7. A113694E01
    Check that the "Learning has completed" is displayed on the tester screen.

    HINT:
    Electronic throttle learning will not be completed if the battery is weak and it produces a momentary voltage drop, even though the battery voltage is 10 V or more when the ignition switch is on (IG).

← BASIC INSPECTION (from Aug 2005)PROBLEM SYMPTOMS TABLE (Aug 2005 – Oct 2005) →