PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built Aug 2005 – Oct 2005
Versions by build date: Aug 2005 – Oct 2005 from Nov 2005
- HINT:
- When a malfunction is not confirmed by a DTC check and the cause of the problem cannot be identified through a basic inspection, troubleshoot according to the priority order indicated in the table below.
- Inspect the fuse and relay before confirming the suspected areas as shown in the chart below.
- When a malfunction is not confirmed by a DTC check and the cause of the problem cannot be identified through a basic inspection, troubleshoot according to the priority order indicated in the table below.
- NOTICE:
- When removing the following parts, follow the precautions on the relevant pages.
| Symptom |
Suspected area |
See page |
| Engine does not crank (Does not start) |
1. Starter signal circuit (Cranking holding function circuit) |
Click here
|
| 2. Battery |
Click here
|
|
| 3. Starter (for 0.8 kW type) |
Click here
|
|
| 4. Starter (for 1.0 kW type) |
Click here
|
|
| 5. ST relay |
Click here
|
|
| 6. VC output circuit |
Click here
|
|
| 7. Clutch start switch |
Click here
|
|
| 8. ECM |
Click here
|
|
| No initial combustion (Does not start) |
1. ECM power source circuit |
Click here
|
| 2. Fuel pump control circuit |
Click here
|
|
| 3. VC output circuit |
Click here
|
|
| 4. ECM |
Click here
|
|
| Incomplete combustion |
1. Fuel pump control circuit |
Click here
|
| Engine cranks normally but difficult to start |
1. Starter signal circuit (Cranking holding function circuit) |
Click here
|
| 2. Fuel pump control circuit |
Click here
|
|
| 3. Compression |
Click here
|
|
| Difficult to start with cold engine |
1. Starter signal circuit (Cranking holding function circuit) |
Click here
|
| 2. Fuel pump control circuit |
Click here
|
|
| Difficult to start with hot engine |
1. Starter signal circuit (Cranking holding function circuit) |
Click here
|
| 2. Fuel pump control circuit |
Click here
|
|
| High engine idling speed |
1. A/C signal circuit (Compressor circuit) for manual air conditioning system |
Click here
|
| 2. A/C signal circuit (Compressor circuit) for automatic air conditioning system |
Click here
|
|
| 3. ECM power source circuit |
Click here
|
|
| Low engine idling speed |
1. A/C signal circuit (Compressor circuit) for manual air conditioning system |
Click here
|
| 2. A/C signal circuit (Compressor circuit) for automatic air conditioning system |
Click here
|
|
| 3. Fuel pump control circuit |
Click here
|
|
| Rough idling (Poor idling) |
1. Compression |
Click here
|
| 2. Fuel pump control circuit |
Click here
|
|
| Hunting (Poor idling) |
1. ECM power source circuit |
Click here
|
| 2. Fuel pump control circuit |
Click here
|
|
| Hesitation/Poor acceleration (Poor drivability) |
1. Fuel pump control circuit |
Click here
|
| Surging (Poor drivability) |
1. Fuel pump control circuit |
Click here
|
| Engine stalls soon after starting |
1. Fuel pump control circuit |
Click here
|
| Engine stalls during A/C operation |
1. A/C signal circuit (Compressor circuit) for manual air conditioning system |
Click here
|
| 2. A/C signal circuit (Compressor circuit) for automatic air conditioning system |
Click here
|
|
| 3. ECM |
Click here
|