2005-2008 Yaris · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2006


1. REMOVE MAGNET STARTER SWITCH ASSEMBLY

  1. A156357
    Remove the nut and disconnect the lead wire from the magnet starter switch assembly terminal.

  1. A156358
    Loosen the 2 nuts holding the magnet starter switch assembly on the starter housing.

  1. A156359
    Pull the magnet starter switch assembly and while lifting the front part of the magnet starter switch assembly, release the plunger hook from the drive lever and magnet starter switch assembly.


2. REMOVE STARTER YOKE ASSEMBLY

  1. A156360
    Remove the 2 through bolts and pull out the end frame together with the armature.


3. REMOVE STARTER BRUSH HOLDER ASSEMBLY

  1. A156361
    Remove the 2 screws and remove the commutator end frame with the lead wire held down.

    NOTICE:
    To avoid interference between the brush holder and the dust protector, pull the commutator end frame away at an angle.

  1. A064784
    Using a screwdriver, hold the spring back and release the 4 starter brushes.

  1. Remove the brush holder assembly.


4. REMOVE STARTER ARMATURE ASSEMBLY

5. REMOVE STARTER CLUTCH SUB-ASSEMBLY

  1. A156362
    Remove the drive lever and starter clutch with shock absorber from the starter housing.

  1. A033589
    Using a screwdriver, tap the stop collar toward the starter clutch.

  1. A033590
    Using a screwdriver, pry off the snap ring.

  1. Remove the stop collar and starter clutch from the planetary shaft.

← REMOVAL (from Nov 2006)INSPECTION (from Nov 2006) →