2005-2008 Yaris · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Aug 2005


INSPECT FUEL INJECTOR ASSEMBLY
  1. Inspect injector resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      11.6 to 12.4 Ω at 20°C (68°F)

      If the resistance is not as specified, replace the injector.

  1. Inspect the injection volume.

    CAUTION:
    This test involves high-pressure fuel and electricity. Take all precautions regarding safe handling of both the fuel and the electricity. Perform this test in a safe area, and avoid any sparks and flames. Do not smoke.


    1. A088228E04
      Install the fuel tube connector to SST (hose), then connect the tube connector to the fuel pipe (the vehicle side).
      SST
      09268-41048   (95336-08070, 90467-13001, 09268-41500)

    2. A075914E02
      Install the O-ring onto the fuel injector.

    3. Connect SST (adaptor and hose) to the injector and hold the injector and union with SST (clamp).

      SST
      09268-41048   (95336-08070, 90467-13001, 09268-41130, 09268-41310)

    4. Set the injector in a graduated cylinder.

      CAUTION:
      Install a suitable vinyl tube onto the injector to prevent gasoline splashing.

    5. Operate the fuel pump (turn the ignition switch ON).

    6. A075915E02
      Connect SST (wire) to the injector and the battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.
      SST
      09842-30080  

      Volume:
      47 to 58 cm3 (2.87 to 3.54 cu in.) in 15 seconds

      Difference between injectors:
      15 cm3 (0.9 cu in.) or less

      If the injection volume is not as specified, replace the injector.

  1. A075916
    Check for leakage.

    1. Disconnect the tester probes of SST (wire) from the battery and check for fuel leakage from the injector as shown in the illustration.

      Fuel drop:
      1 drop or less every 5 minutes

← REMOVAL (from Aug 2005)INSTALLATION (from Aug 2005) →