2005-2008 Yaris · Service Manual ENGINE

ECM Back-up Power Source Circuit

Circuit diagnosis · Vehicles built from Aug 2005

DESCRIPTION

The battery supplies electricity to terminal BATT of the ECM even when the ignition switch is off. This electricity allows the ECM to store DTC histories, freeze frame data, fuel trim values and other data.

WIRING DIAGRAM

A109134E01

INSPECTION PROCEDURE


1. INSPECT FUSE (EFI FUSE)
A116138E01
  1. Remove the EFI fuse from the engine room relay block.

  1. Check the EFI fuse resistance.

    Standard resistance:
    Below 1 Ω

  1. Reinstall the EFI fuse.



NG
CHECK FOR SHORT IN ALL HARNESS AND COMPONENTS CONNECTED TO FUSE, AND REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (ECM - INTEGRATION RELAY)
A116139E01
  1. Remove the EFI fuse from the engine room relay block.

  1. Disconnect the ECM connector.

  1. Check the resistance.

    Standard resistance (Check for open):
    Tester Connection
    Specified Condition
    BATT (A32-22) - EFI fuse holder (2)
    Below 1 Ω

    Standard resistance (Check for short):
    Tester Connection
    Specified Condition
    BATT (A32-22) - Body ground
    10 kΩ or higher

  1. Reinstall the EFI fuse.

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (ECM - INTEGRATION RELAY)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (INTEGRATION RELAY - BATTERY)


← VC Output Circuit (from Aug 2005)Fuel Pump Control Circuit (from Aug 2005) →