Entire Combination Meter does not Operate
Circuit diagnosis · Vehicles built from Aug 2005
DESCRIPTION
This circuit provides power to the combination meter assembly.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK FUSE (ECU-B, MET) |
Remove the ECU-B fuse from the engine room relay block.

Remove the MET fuse from the main body ECU.
Measure the resistance.
- Standard Resistance:
- Below 1Ω
Reinstall the fuses.
|
|
||||
| OK | |
| 2. INSPECT COMBINATION METER ASSEMBLY |
![]() ![]() |
Disconnect the D1 combination meter assembly connector.
Measure the resistance.
- Standard resistance:
Terminal No.
Condition
Specified Condition
D1-24 (ET) - Body ground
Always
Below 1 Ω
Measure the voltage.
- Standard voltage:
Terminal No.
Condition
Specified Condition
D1-1 (IG2) -
Body ground
Ignition switch on (IG)
10 to 14 V
D1-2 (ECU-B) -
Body ground
Always
10 to 14 V
Reconnect the combination meter assembly connector.
|
|
||||
| OK | ||
| ||

