2005-2008 Yaris · Service Manual BODY ELECTRICAL

U0129 Lost Communication with Skid Control ECU

Diagnostic trouble codes · Vehicles built from Aug 2005

DESCRIPTION

The combination meter assembly receives signals from the ABS and traction actuator or the brake actuator through the CAN communication system.
DTC No.
DTC Detecting Conditions
Trouble Areas
U0129
When either of following conditions detected:
  1. 15 seconds have elapsed since engine started and IG voltage 10.5 V or more
  2. No communication with ABS and traction actuator (w/ VSC), Brake actuator (w/ ABS) continues for 3 seconds or more (Communication with neither ECM nor skid control ECU for 60 seconds or more)
  1. CAN communication system
  2. ABS and traction actuator (w/ VSC)
  3. Brake actuator (w/ ABS)

WIRING DIAGRAM

E114498E20

INSPECTION PROCEDURE


1. CONFIRM DTC OUTPUT
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) (do not start the engine) and turn the tester on.

  1. Clear the stored DTCs by selecting the following menu items on the tester: Body/ Combination Meter/ DTC /Clear.

  1. Start the engine and wait for at least 60 seconds.

  1. Check for DTCs.

    Result:
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
SYSTEM IS OK
A

GO TO CAN COMMUNICATION SYSTEM


← U0100 Lost Communication with ECM / PCM "A" (from Aug 2005)Entire Combination Meter does not Operate (from Aug 2005) →