2005-2008 Yaris · Service Manual RESTRAINTS

INSTALLATION

Removal / installation · Vehicles built from Nov 2005

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/ Front Seat Side Airbag) (Click here).

NOTICE:
Always use "Torx" socket wrench E10 when installing the front seat.

HINT:
The procedure described below is for the LHD. Use the same procedure for both the RHD and LHD, unless otherwise specified.


1. INSTALL FRONT SEAT CUSHION COVER PAD (Built in Occupant Detection Sensor)

  1. B126905
    Install the front seat cushion cover pad and engage the 2 hooks.

  1. Install the 3 bands.

  1. Engage the claw and connector.

  1. B134757
    Engage the 7 hooks.


2. INSTALL FRONT SEAT CUSHION INNER SHIELD

HINT:
Use the same procedure as for the driver side (Click here).


3. INSTALL FRONT SEAT INNER BELT ASSEMBLY

  1. B134759E01
    Install the front seat inner belt with the bolt.

    Torque:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Do not place the front seat inner belt over the convex area of the front seat frame adjuster.

  1. B124386
    w/ Seat Heater System:

    1. Connect the seat heater connector.

  1. Connect the occupant detection sensor connector.

  1. Install the wire harness into the claw of the front seat frame adjuster.

  1. Install the 2 clamps.

  1. Engage the claw and install the buckle switch connector.


4. INSTALL FRONT SEAT CUSHION OUTER SHIELD

HINT:
Use the same procedure as for the driver side (Click here).


5. INSTALL RECLINING ADJUSTER RELEASE HANDLE

HINT:
Use the same procedure as for the driver side (Click here).


6. INSTALL RECLINING ADJUSTER KNOB CAP

HINT:
Use the same procedure as for the driver side (Click here).


7. INSTALL FRONT SEAT ASSEMBLY

HINT:
Use the same procedure as for the driver side (Click here).


8. INSTALL FRONT SEAT UNDER TRAY (w/ Under Tray)

  1. B126912
    Hitch the front seat under tray into the seat track, and then slide it along the seat track to install it.


9. INSTALL FRONT SEAT HEADREST ASSEMBLY

  1. B124372E01
    Push in the lock button of the front seat headrest support and install the front seat headrest.


10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


11. INSPECT SRS WARNING LIGHT (w/ Front Seat Side Airbag)
(Click here)
← INSPECTION (from Nov 2005)PRECAUTION (from Aug 2005) →