2005-2008 Yaris · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Aug 2005

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/ Front Seat Side Airbag) (Click here).

NOTICE:
Always use "Torx" socket wrench E10 when removing the front seat.

HINT:
The procedure described below is for the LHD. Use the same procedure for both RHD and LHD, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working (w/ Front Seat Side Airbag).


2. REMOVE FRONT SEAT HEADREST ASSEMBLY

  1. B138677E01
    Push in the lock button of the front seat headrest support and remove the front seat headrest.


3. REMOVE FRONT SEAT UNDER TRAY (w/ Under Tray)

  1. B119870
    Remove the front seat under tray.


4. REMOVE FRONT SEAT ASSEMBLY

HINT:
Use the same procedure as for the driver side (Click here).


5. REMOVE RECLINING ADJUSTER RELEASE HANDLE

  1. B121709E01
    Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the reclining adjuster release handle.


6. REMOVE FRONT SEAT CUSHION SHIELD RH

  1. B121710
    Remove the screw.

  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and the clip and remove the front seat cushion shield.


7. REMOVE FRONT SEAT INNER BELT ASSEMBLY

  1. B127000
    Disengage the 2 hooks and remove the front seat cushion cover.

  1. Disconnect the occupant detection sensor connector.

  1. w/ Seat Heater System:

    1. Disconnect the seat heater connector.

  1. Remove the buckle switch connector.

  1. Remove the 5 wiring harness clamps.

  1. B114762
    Remove the wiring harness from the claw of the front seat cushion shield.

  1. Remove the bolt and the front seat inner belt.


8. REMOVE FRONT SEAT CUSHION SHIELD LH

  1. B121711
    Remove the screw.

  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and the clip and remove the front seat cushion shield.


9. REMOVE FRONT SEAT CUSHION COVER PAD (Built in Occupant Detection Sensor)

  1. B119875
    Remove the front seatback cover band.

  1. B114700E01
    for Clip Type:

    1. Using a clip remover, remove the 2 clips.

  1. for J Hook Type:

    1. Disengage the 2 hooks.

  1. w/ Front Seat Side Airbag:

    1. Remove the hook tape and remove the front seat cushion cover pad fixing cover.

  1. B119876
    Remove the occupant detection sensor connector.

  1. w/ Seat Heater System:

    1. Disengage the 2 claws and the 9 hooks.

    2. Disconnect the seat heater connector and remove the front seat cushion cover pad.

  1. w/o Seat Heater System:

    1. Disengage the 2 claws and the 9 hooks and remove the front seat cushion cover pad.

← COMPONENTS (from Aug 2005)INSPECTION (from Aug 2005) →