2005-2008 Yaris · Service Manual HEATER & AIR CONDITIONING SYSTEM

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Aug 2005

HINT:
  1. Use these procedures to troubleshoot the air conditioning system.
  2. Use an intelligent tester in steps 4, 5 and 8.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK
      NEXT

      3.INSPECT BATTERY VOLTAGE

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding.
      NEXT

      4.CHECK LIN COMMUNICATION SYSTEM
      1. Use an intelligent tester to check if the LIN communication system is functioning.

        Result:
        Result
        Proceed to
        LIN DTC is not output
        A
        LIN DTC is output
        B


      B.
      A

      5.CHECK CAN COMMUNICATION SYSTEM
      1. Use an intelligent tester to check if the CAN communication system is functioning.

        Result:
        Result
        Proceed to
        CAN DTC is not output
        A
        CAN DTC is output
        B


      B.
      A

      6.CHECK DTCs OR CHECK SENSOR CHECK CODES THROUGH PANEL DIAGNOSIS
      1. Check DTCs or sensor check codes.

        1. Write down the DTCs or sensor check codes.

      2. Clear the DTCs or sensor check codes.

      3. Check whether the DTCs or sensor check codes recur.

        1. Reproduce the problem symptoms in accordance with the DTCs or sensor check codes that were written down, and check whether the DTCs or sensor check codes recur.

          HINT:
          Refer to the DTC chart when any DTCs or sensor check codes are output.

          Result:
          Result
          Proceed to
          DTC or sensor check code is not output
          A
          DTC or sensor check code is output
          B


      B.
      A

      7.REFER TO PROBLEM SYMPTOMS TABLE
      1. Problem symptoms table (Click here)


      2. Result:
        Result
        Proceed to
        Fault not listed in problem symptoms table
        A
        Fault listed in problem symptoms table
        B


      B.
      A

      8.OVERALL ANALYSIS AND TROUBLESHOOTING
      1. Data List / Active Test (Click here)

      2. Diagnosis system (Click here)

        1. Panel diagnosis (indicator check)

        2. Panel diagnosis (actuator check)

      3. Terminals of ECU (Click here)

      NEXT

      9.ADJUST, REPAIR OR REPLACE
        NEXT

        10.CONFIRMATION TEST
          NEXT

          ← SYSTEM DESCRIPTION (from Aug 2005)PROBLEM SYMPTOMS TABLE (Aug 2005 – Oct 2005) →