2005-2008 Yaris · Service Manual BRAKE

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSTALL REAR WHEEL BRAKE CYLINDER ASSEMBLY

C130275
  1. Install the wheel brake cylinder with the 2 bolts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

  1. Provisionally install the bleeder plug.

  1. Install the bleeder plug cap.

  1. C130274E01
    Using SST, install the brake tube.
    SST
    09023-00100  

    Torque:
    for use without SST:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }
    for use with SST:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }

    HINT:
    1. Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
    2. This torque value is effective when SST is parallel to a torque wrench.


2. APPLY HIGH TEMPERATURE GREASE

C130277E01
  1. Apply high temperature grease to the surface of the backing plate which is in contact with the shoe.


3. INSTALL REAR BRAKE SHOE

C130273
  1. Using needle-nose pliers, connect the parking brake cable onto the parking brake shoe lever.

  1. C130272
    Using pliers, install the rear brake shoe, pin and shoe hold down spring.


4. INSTALL PARKING BRAKE SHOE STRUT SET

C130278E01
  1. Apply high temperature grease to the adjusting bolt.

  1. C130279E01
    Install the parking brake shoe strut set as shown in the illustration.


5. INSTALL FRONT BRAKE SHOE

C130271
  1. Using pliers, install the front brake shoe, pin and shoe hold down spring.

  1. C129776E01
    Using SST, install the tension spring.
    SST
    09703-30010  

  1. C129775E01
    Using SST, install the return shoe spring.
    SST
    09703-30010  

    NOTICE:
    Do not damage the wheel cylinder boot.


6. CHECK REAR DRUM BRAKE INSTALLATION

  1. Check that each part is installed properly.

    C130280E01

    NOTICE:
    There should be no oil or grease adhering to the friction surfaces of the shoe lining or the drum.

← INSPECTION (from Nov 2005)INSTALLATION (from Nov 2005) →