C1249/49 Open in Stop Light Switch Circuit
Diagnostic trouble codes · Vehicles built from Aug 2005
DESCRIPTION
The skid control ECU detects the brake operating conditions through a signal transmitted by the stop light switch. The skid control ECU incorporates an open circuit detection circuit. This DTC is set under either of the following conditions:- An open is detected in the stop light signal input line when the stop light switch is off.
- An open is detected in the stop light circuit lead to the ground when the stop light switch is off.
| DTC No. |
DTC Detecting Conditions |
Trouble Areas |
| C1249/49 |
When IG1 terminal voltage 9.5 to 17.2 V, open circuit of stop light switch continues for 0.3 seconds or more. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK STOP LIGHT SWITCH OPERATION |
Connect the intelligent tester to the DLC3.

Turn the ignition switch on (IG).
Turn the tester on.
Select the DATA LIST mode on the intelligent tester.Select the following menu items: Chassis / ABS/VSC/TRC / Data List.
DATA LIST: ABS/VSC/TRC Item (Display)
Measurement Item / Range (Display)
Normal Conditions
Stop Lamp SW
Stop light switch / ON or OFF
ON: Brake pedal depressed
OFF: Brake pedal released
Check that "Stop Lamp SW" is turned ON and OFF when the brake pedal is depressed and released.
- OK:
- "Stop Lamp SW" is turned ON and OFF in accordance with the operation of the brake pedal.
|
|
||||
| OK | |
| 2. CHECK SKID CONTROL ECU TERMINAL VOLTAGE (STP) |
Disconnect the skid control ECU connector.
Measure the voltage.

- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
A31-27 (STP) - Body ground
Brake pedal depressed
8 to 14 V
A31-27 (STP) - Body ground
Brake pedal released
Below 4.0 V
|
|
||||
| OK | ||
| ||
| 3. INSPECT FUSE (STOP) |
Remove the STOP fuse from the main body ECU.

Measure the resistance.
- Standard Resistance:
- Below 1 Ω
|
|
||||
| OK | |
| 4. INSPECT STOP LIGHT SWITCH ASSEMBLY |
![]() ![]() |
Disconnect the stop light switch connector.
Measure the resistance.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
1 - 2
Switch pin released
Below 1 Ω
3 - 4
Switch pin released
10 kΩ or higher
1 - 2
Switch pin pushed in
10 kΩ or higher
3 - 4
Switch pin pushed in
Below 1 Ω
|
|
||||
| OK | |
| 5. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - STOP LIGHT SWITCH) |
Disconnect the skid control ECU connector and stop light switch connector.
Measure the resistance.

- Standard Resistance:
Tester Connection
Specified Condition
A31-27 (STP) - A13-1
Below 1 Ω
|
|
||||
| OK | |
| 6. RECONFIRM DTC |
Clear the DTC (Click here).
Check if the same DTC is output (Click here).
Result
Proceed to
DTC output
A
DTC not output
B
|
|
||||
| A | ||
| ||

