C1246/46 Master Cylinder Pressure Sensor Malfunction
Diagnostic trouble codes · Vehicles built from Aug 2005
Also covers:
- C1281/81 Master Cylinder Pressure Sensor Output Malfunction (Test Mode DTC)
DESCRIPTION
The master cylinder pressure sensor is connected to the skid control ECU in the ABS and TRACTION actuator.DTC C1281/81 can be detected when the master cylinder pressure sensor sends a master cylinder pressure signal or test mode ends. DTC C1281/81 is output only in test mode.
| DTC No. |
DTC Detecting Conditions |
Trouble Areas |
| C1246/46 |
When any of following conditions detected:
|
|
| C1281/81 |
Detected only during test mode. |
|
INSPECTION PROCEDURE
- NOTICE:
- When replacing the ABS and TRACTION actuator, perform zero point calibration (Click here).
| 1. READ VALUE OF DATA LIST (STOP LIGHT SWITCH) |
Connect the intelligent tester to the DLC3.
Turn the tester on.
Select the DATA LIST mode on the intelligent tester.Select the following menu items: Chassis / ABS/VSC/TRC / Data List.
DATA LIST: ABS/VSC/TRC Item (Display)
Measurement Item : Range (Display)
Normal Condition
Stop Lamp SW
Stop light switch : ON or OFF
ON: Brake pedal applied
OFF: Brake pedal released
Check that "Stop Lamp SW" turns ON and OFF when the brake pedal is depressed and released.
- OK:
- "Stop Lamp SW" turns ON and OFF in accordance with the operation of the brake pedal.
|
|
||||
| OK | |
| 2. READ VALUE OF DATA LIST (MASTER CYLINDER PRESSURE SENSOR) |
Connect the intelligent tester to the DLC3.
Start the engine.
Turn the tester on.
Read the output voltage of the master cylinder pressure sensor using the intelligent tester.Select the following menu items: Chassis / ABS/VSC/TRC / Data List.
DATA LIST: ABS/VSC/TRC Item (Display)
Measurement Item : Range (Display)
Normal Condition
Master Cylinder Sensor
Master cylinder pressure sensor 1 reading : min.: 0 V, max.: 5 V
When brake pedal released: 0.3 to 0.9 V
Check that the master cylinder pressure sensor reading increases when the brake pedal is depressed.
- OK:
- The sensor output voltage increases.
|
|
||||
| OK | |
| 3. RECONFIRM DTC |
Clear the DTC(s) (Click here).
Drive the vehicle at a speed of 30 km/h (18 mph) or more and perform a braking test (decelerate the vehicle by depressing the brake pedal).
Check if the same DTC(s) is recorded (Click here).
Result
Proceed to
DTC output
A
DTC not output
B
|
|
||||
| A | ||
| ||
