2005-2008 Yaris · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Aug 2005

CAUTION:
Some of the these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

NOTICE:
Always use "Torx" socket wrench E10 when installing the rear seat.

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)

  1. B114569E01
    Remove the 2 package tray trim suspenders.

  1. Remove the 5 pieces of hook tape.

  1. Disengage the 2 claws and remove the package tray trim.


3. REMOVE DECK BOARD SUB-ASSEMBLY (w/ Deck Board)

  1. B106371
    Release the 2 knobs and remove the deck board.


4. REMOVE SPARE WHEEL COVER ASSEMBLY (w/ Deck Board)

  1. B119913
    Remove the spare wheel cover.


5. REMOVE DECK FLOOR BOX RH (w/ Deck Board)

  1. B106372
    Release the 2 knobs and remove the deck floor box.


6. REMOVE DECK FLOOR BOX LH (w/ Deck Board)

HINT:
Use the same procedure as for the RH side.


7. REMOVE REAR FLOOR CARPET ASSEMBLY (w/o Deck Board)

  1. B119912
    Remove the rear floor carpet.


8. REMOVE NO. 1 REAR SEAT LEG COVER
  1. for RH Side:

    1. Remove the No. 1 rear seat leg cover (Click here).

  1. for LH Side:

    1. Remove the No. 1 rear seat leg cover (Click here).


9. REMOVE NO. 2 REAR SEAT LEG COVER

  1. B126921E01
    Disengage the 3 claws in the sequence shown in the illustration and remove the No. 1 rear seat leg cover.


10. REMOVE REAR SEAT ASSEMBLY RH

  1. B114660
    Using "Torx" socket wrench E10, remove the 2 bolts and pull up the rear seat cushion.

  1. B119885
    Using "Torx" socket wrench E10, remove the 4 bolts and the rear seat.


11. REMOVE REAR SEAT ASSEMBLY LH

  1. B114740
    Using "Torx" socket wrench E10, remove the 3 bolts and pull up the rear seat cushion.

  1. B117760
    Using "Torx" socket wrench E10, remove the 4 bolts and the rear seat.


12. REMOVE REAR DECK TRIM COVER

  1. B117692
    for Temper Spare Tire:

    1. Using a clip remover, remove the 2 clips.

    2. Disengage the 8 claws and remove the rear deck trim cover.

  1. B114283
    for Grand Tire:

    1. Using a clip remover, remove the 2 clips.

    2. Disengage the 8 claws and remove the rear deck trim cover.


13. REMOVE REAR DOOR SCUFF PLATE RH

  1. B114287
    Disengage the 6 claws and remove the rear door scuff plate.


14. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH

B114288
  1. Remove the rear opening trim weatherstrip to the extent necessary to remove the deck trim panel side.


15. REMOVE REAR SEAT OUTER BELT ASSEMBLY RH

  1. B114289
    Remove the belt.

  1. B130498
    Remove the bolt.

  1. Disengage the clip and remove the anchor plate.


16. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH

  1. C123146E01
    w/ Package Tray Trim:

    1. Remove the 3 screws.

    2. Disengage the 3 clips and the 6 claws and remove the deck trim side panel.

      HINT:
      When removing the deck trim side panel assembly LH from the vehicle with the luggage compartment room light, disconnect the room light connector and then remove the deck trim side panel assembly.

  1. C123147E01
    w/o Package Tray Trim:

    1. Remove the 3 screws.

    2. Disengage the 4 clips and the 6 claws and remove the deck trim side panel.

      HINT:
      When removing the deck trim side trim side panel assembly LH from the vehicle with the luggage compartment room light, disconnect the room light connector and then remove the deck trim side panel assembly.


17. REMOVE REAR AIRBAG SENSOR

CAUTION:
Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.

  1. B106577E01
    Slide the outer housing and detach the airbag connector.

  1. B106578E01
    Engage the bolt and hook and remove the airbag sensor.

← ON-VEHICLE INSPECTION (from Aug 2005)INSTALLATION (from Aug 2005) →