2005-2008 Yaris · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE REAR WHEEL

3. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY (for Rear Drum Brake)
  1. Release the parking brake and remove the rear brake drum.
    If the rear brake drum cannot be removed easily, perform the following procedure.

  1. for Manual Transaxle:

    1. Remove the shift lever knob.

    2. Remove the shifting hole cover (Click here).

  1. Remove the console box rear cover (Click here).

  1. Remove the console box carpet (Click here).

  1. Remove the rear console box (Click here).

  1. C129772
    Loosen the wire adjusting nut.

    NOTICE:
    Do not reuse the loosened nut.

  1. C129773
    Remove the hole plug.

  1. C129774E01
    Insert SST through the hole in the backing plate, pull the parking brake shoe lever toward the rear of the vehicle and remove the rear brake drum.
    SST
    09921-00010  


4. DISCONNECT PARKING BRAKE CABLE ASSEMBLY (for Rear Disc Brake)

C129757
  1. Disconnect the cable end from the rear disc brake cylinder operation lever.

  1. Using needle-nose pliers, disengage the claws of the casing cap and disconnect the parking brake cable.


5. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY (for Rear Disc Brake)

C130313
  1. Remove the 2 bolts and separate the disc brake caliper from the rear axle beam.

    NOTICE:
    Hang the caliper using a piece of string or the equivalent


6. REMOVE REAR DISC (for Rear Disc Brake)

C108951E01
  1. Place matchmarks on the disc and axle hub and remove the disc.


7. DISCONNECT SKID CONTROL SENSOR WIRE

C125279
  1. Using a screwdriver, remove the claw of the connector lock portion and disconnect the skid control sensor wire connector.

    NOTICE:
    Do not remove the connector cover from the connector because the skid control sensor wire may be damaged.


8. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY

C130314E01
  1. for Rear Drum Brake:

    1. Remove the 4 bolts and remove the axle hub and bearing from the axle beam.

      NOTICE:
      Suspend the backing plate with a piece of rope.

  1. for Rear Disc Brake:

    1. Remove the 4 bolts and remove the axle hub and bearing and the dust cover from the axle beam.

← COMPONENTS (from Nov 2005)INSTALLATION (from Nov 2005) →