2005-2008 Yaris · Service Manual BRAKE

C1201/51 Engine Control System Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

If a malfunction in the engine control system is detected, the operations of VSC and TRC are prohibited by the fail-safe function. When the signals from the engine are input normally, the fail-safe is cancelled and the DTC is not stored.
DTC No.
DTC Detecting Conditions
Trouble Areas
C1201/51
Engine control system malfunction signal continues for 5 seconds.
Engine control system

INSPECTION PROCEDURE

NOTICE:
When replacing the ABS and TRACTION actuator, perform zero point calibration (Click here).


1. CHECK ENGINE CONTROL SYSTEM
  1. Clear the DTC (engine control system).

  1. Check for the DTC (engine control system).

    Result:
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPAIR ENGINE CONTROL SYSTEM


← C0371/71 Yaw Rate Sensor (Test Mode DTC) (+ C1232/32, C1234/34, C1279/79) (from Nov 2005)C1202/52 Brake Fluid Level Low / Open Circuit in Brake Fluid Level Warning Switch Circuit (from Nov 2005) →