2005-2008 Yaris · Service Manual BRAKE

C1202/52 Brake Fluid Level Low / Open Circuit in Brake Fluid Level Warning Switch Circuit

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

The brake fluid level warning switch sends the appropriate signal to the skid control ECU when the brake fluid level drops.
DTC No.
DTC Detecting Condition
Trouble Areas
C1202/52
Low fluid level condition in the brake master cylinder reservoir tank continues for 60 seconds.
  1. Brake fluid level
  2. Brake fluid level warning switch
  3. Brake fluid level warning switch circuit
  4. Skid control ECU

WIRING DIAGRAM

C129359E01

INSPECTION PROCEDURE

NOTICE:
When replacing the ABS and TRACTION actuator, perform zero point calibration (Click here).


1. CHECK BRAKE FLUID LEVEL
  1. Turn the ignition switch off.

  1. Check the amount of fluid in the brake reservoir.

    OK:
    Brake fluid level is correct.



NG
ADD BRAKE FLUID
OK


2. CHECK BRAKE FLUID LEVEL WARNING SWITCH

  1. C129358E01
    Remove the reservoir tank cap and strainer.

  1. Disconnect the brake fluid level warning switch connector.

  1. Measure the resistance.

    HINT:
    A float is placed inside the reservoir. Its position can be changed by increasing or decreasing the brake fluid level.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A36-1 - A36-2
    Float up (Switch OFF)
    10 kΩor higher
    A36-1 - A36-2
    Float down (Switch ON)
    Below 1 Ω

    HINT:
    If the result is as specified, adjust the brake fluid level to the MAX level after measuring the resistance.



NG
REPLACE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
OK


3. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BRAKE FLUID LEVEL WARNING SWITCH)

  1. C129352E01
    Disconnect the skid control ECU connector.

  1. Disconnect the brake fluid level warning switch connector.

  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    A39-20 (LVL2) - A36-2
    Below 1 Ω
    A39-20 (LVL2) - Body ground
    10 kΩ or higher
    A36-1 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Check if the same DTC is recorded (Click here).


Result:
Result
Proceed to
DTC output
A
DTC not output
B



B
END
A

REPLACE ABS AND TRACTION ACTUATOR


← C1201/51 Engine Control System Malfunction (from Nov 2005)C1203/53 ECM Communication Circuit Malfunction (from Nov 2005) →