2005-2008 Yaris · Service Manual BRAKE

C1203/53 ECM Communication Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

A new skid control ECU is supplied without engine variation data. Until it is recognized by the ECU, DTC C1203/53 remains stored. By entering test mode, recognition of engine variation data is automatically conducted, and DTC C1203/53 is erased automatically.
DTC No.
DTC Detecting Condition
Trouble Area
C1203/53
When all of following conditions detected:
  1. Engine variation data from ECM does not match one in skid control ECU non-volatile memory.
  2. DTC U0073/94 not detected.
  3. DTC U0100/65 not detected.
  1. Test mode not performed
  2. ABS and TRACTION actuator (skid control ECU)

INSPECTION PROCEDURE

NOTICE:
When replacing the ABS and TRACTION actuator, perform zero point calibration (Click here).


1. PERFORM TEST MODE INSPECTION
  1. Perform a TEST MODE inspection (Click here).


NEXT


2. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Start the engine.

  1. Check if the same DTC is output (Click here).

    Result:
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPLACE ABS AND TRACTION ACTUATOR


← C1202/52 Brake Fluid Level Low / Open Circuit in Brake Fluid Level Warning Switch Circuit (from Nov 2005)C1207/37 Multi-Mode Manual Transmission System Malfunction (from Nov 2005) →