VSC Warning Light Remains ON
Circuit diagnosis · Vehicles built from Aug 2005
DESCRIPTION
If the skid control ECU stores any DTCs which relate to the VSC system, the VSC warning light comes on in the combination meter.The skid control ECU is connected to the combination meter via the CAN communication system.
WIRING DIAGRAM




INSPECTION PROCEDURE
- NOTICE:
- When replacing the ABS and TRACTION actuator, perform the zero point calibration (Click here).
| 1. CHECK CAN COMMUNICATION SYSTEM |
Check if the CAN communication system DTC is output (Click here).
Result
Proceed to
DTC not output
A
DTC output
B
|
|
||||
| OK | |
| 2. CHECK SKID CONTROL ECU CONNECTOR |
Check if the skid control ECU connector is securely connected.
- OK:
- The connector is securely connected.
|
|
||||
| OK | |
| 3. INSPECT COMBINATION METER |
Check the combination meter assembly (Click here).
|
|
||||
| OK | ||
| ||
