2005-2008 Yaris · Service Manual BODY ELECTRICAL

B1249 Double Locking ECU Communication Stop

Diagnostic trouble codes · Vehicles built from Aug 2005

DESCRIPTION

DTC B1249 is output when the communication between the double door lock ECU and the main body ECU stops for more than 10 seconds.
DTC No.
DTC Detection Condition
Trouble Area
B1249
No communication from double door lock ECU for more than 10 seconds.
  1. Double door lock ECU assembly
  2. Main body ECU assembly
  3. Wire harness and connector

WIRING DIAGRAM

B123829E03

INSPECTION PROCEDURE


1. READ VALUE OF INTELLIGENT TESTER (Comm Double Lock)
  1. Check the DATA LIST to ensure the proper operation of the double door lock ECU.

    Main Body ECU:
    Item
    Measurement Item / Display (Range)
    Normal Condition
    Diagnostic Note
    Comm Double Lock
    Double door lock ECU signal / OK or STOP
    OK: Double door lock ECU signal is normal
    STOP: Double door lock ECU signal is abnormal
    -



NG
REPLACE MAIN BODY ECU
OK


2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - DOUBLE DOOR LOCK ECU)

  1. B123842E02
    w/o Entry and start system:
    1. Disconnect the D69 double door lock ECU and D33 main body ECU connectors.

    2. Measure the resistance of the wire harness side connectors.

      Standard resistance:
      Tester Connection
      Specified Condition
      D69-9 (MPX1) - D33-4 (CANP)
      Below 1 Ω
      D69-9 (MPX1) or D33-4 (CANP) - Body ground
      10 kΩ or higher
      D69-14 (GND) - Body ground
      Below 1 Ω

    3. Reconnect the and double door lock ECU and main body ECU connectors.

  1. B123859E02
    w/ Entry and start system:
    1. Disconnect the D69 double door lock ECU and D64 main body ECU connectors.

    2. Measure the resistance of the wire harness side connectors.

      Standard resistance:
      Tester Connection
      Specified Condition
      D69-9 (MPX1) - D64-23 (CANP)
      Below 1 Ω
      D69-9 (MPX1) or D64-23(CANP) - Body ground
      10 kΩ or higher
      D69-14 (GND) - Body ground
      Below 1 Ω

    3. Reconnect the double door lock ECU and main body ECU connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT DOUBLE DOOR LOCK ECU
B123860E02
  1. Disconnect the D69 double door lock ECU connector.

  1. Check the voltage between the wire harness side connector and body ground.

    Standard voltage:
    Tester Connection
    Specified Condition
    D69-1 (+B) - Body ground
    10 to 14 V

  1. Reconnect the double door lock ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE DOUBLE DOOR LOCK ECU


← ON-VEHICLE INSPECTION (from Aug 2005)B2325 LIN Communication Bus Malfunction (from Aug 2005) →