2005-2008 Yaris · Service Manual BODY ELECTRICAL

U0100 Lost Communication with ECM / PCM "A"

Diagnostic trouble codes · Vehicles built from Aug 2005

DESCRIPTION

The combination meter assembly and the ECM exchange signals through the CAN communication system.
DTC No.
DTC Detecting Conditions
Trouble Areas
U0100
When either of following conditions detected:
  1. Vehicle speed 5 km/h (3.1 mph) or more and IG voltage 10.5 V or more
  2. No communication with ECM continues for 3 seconds or more (Communication with neither ECM nor skid control ECU for 60 seconds or more)
  1. ECM
  2. CAN communication system

WIRING DIAGRAM

E114498E04

INSPECTION PROCEDURE


1. CONFIRM DTC OUTPUT
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) (do not start the engine) and turn the intelligent tester on.

  1. Clear the stored DTCs by selecting the following menu items on the tester: Body/ Combination Meter/ DTC /Clear.

  1. Drive the vehicle at more than 5 km/h (3.1 mph) for at least 60 seconds.

  1. Stop the vehicle.

  1. Check for DTCs.

    Result:
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
SYSTEM IS OK
A

GO TO CAN COMMUNICATION SYSTEM


← ON-VEHICLE INSPECTION (from Aug 2005)U0129 Lost Communication with Skid Control ECU (from Aug 2005) →