2005-2008 Yaris · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Nov 2006


INSPECT GENERATOR CLUTCH PULLEY

  1. A153719E01
    Hold the center of the pulley, and confirm that the outer ring turns counterclockwise and does not turn clockwise.
    If the result is not as specified, replace the clutch pulley.


INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

  1. A128079E01
    Using vernier calipers, measure the length of the exposed brushes.

    Standard exposed length:
    9.5 to 11.5 mm (0.374 to 0.453 in.)

    Minimum exposed length:
    4.5 mm (0.177 in.)

    If the exposed length is less than the minimum, replace the brush holder assembly.


INSPECT GENERATOR ROTOR ASSEMBLY

  1. B012264E15
    Check the generator rotor for an open circuit.

    1. Using an ohmmeter, measure the resistance between the slip rings.

      Standard resistance:
      Tester connection
      Specified condition
      Slip ring - Slip ring
      2.3 to 2.7 kΩ at 20°C (68°F)

      If the result is not as specified, replace the generator rotor assembly.

  1. B012265E01
    Check the rotor for ground.

    1. Using an ohmmeter, measure the resistance between the slip ring and rotor.

      Standard resistance:
      Tester connection
      Specified condition
      Slip ring - Rotor
      1 MΩ or higher

      If the result is not as specified, replace the generator rotor assembly.

  1. A158899
    Check that the generator rotor bearing is not rough or worn.
    If necessary, replace the generator rotor assembly.

  1. A153815E01
    Using vernier calipers, measure the slip ring diameter.

    Standard diameter:
    14.2 to 14.4 mm (0.559 to 0.567 in.)

    Minimum diameter:
    14.0 mm (0.551 in.)

    If the diameter is less than the minimum, replace the generator rotor assembly.


INSPECT GENERATOR DRIVE END FRAME BEARING

  1. A153387
    Check that the bearing is not rough or worn.
    If necessary, replace the generator drive end frame bearing.

← DISASSEMBLY (from Nov 2006)REASSEMBLY (from Nov 2006) →