2005-2008 Yaris · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Nov 2006


1. INSTALL GENERATOR DRIVE END FRAME BEARING

  1. A153388E01
    Using SST and a press, press in a new generator drive end frame bearing.
    SST
    09950-60010   (09951-00470)
    09950-70010   (09951-07100)

  1. A153389E01
    Fit the tabs on the retainer plate into the cutouts on the drive end frame to install the retainer plate.

  1. Install the 4 screws.

    Torque:
    2.3 N*m{ 23 kgf*cm , 20 in.*lbf }


2. INSTALL GENERATOR ROTOR ASSEMBLY
  1. Place the drive end frame on the clutch pulley.

  1. A153384
    Install the generator rotor assembly onto the drive end frame.

  1. A118365
    Place the generator washer on the generator rotor.


3. INSTALL GENERATOR COIL ASSEMBLY

  1. A153390E01
    Using SST and a press, slowly press in the generator coil assembly.
    SST
    09612-70100   (09612-07240)

  1. A153382
    Install the 4 bolts.

    Torque:
    5.8 N*m{ 59 kgf*cm , 51 in.*lbf }


4. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY

  1. A158992E03
    While pushing the 2 brushes into the generator brush holder assembly, insert a φ1.0 mm (0.039 in.) pin into the brush holder hole.

  1. A153391
    Install the brush holder assembly onto the generator coil with the 2 screws.

    Torque:
    1.8 N*m{ 18 kgf*cm , 16 in.*lbf }

  1. A153392
    Pull out the pin from the generator brush holder.


5. INSTALL GENERATOR TERMINAL INSULATOR

  1. A153393
    Install the terminal insulator onto the generator coil.

    NOTICE:
    Pay attention to installation direction of the terminal insulator.


6. INSTALL GENERATOR REAR END COVER

  1. A153379
    Install the generator rear end cover onto the generator coil with the 3 nuts.

    Torque:
    4.6 N*m{ 47 kgf*cm , 41 in.*lbf }


7. INSTALL GENERATOR CLUTCH PULLEY
  1. Temporarily install the clutch pulley onto the rotor shaft.

  1. A128084E01
    Set SST (A) and (B).
    SST
    09820-63020  

  1. A159979E01
    Clamp SST (A) in a vise.

  1. Place the rotor shaft end into SST (A).

  1. A159980E01
    Fit SST (B) to the clutch pulley.

  1. A153394E02
    Tighten the pulley by turning SST (B) in the direction shown in the illustration.

    Torque:
    without SST:
    111 N*m{ 1127 kgf*cm , 82 ft.*lbf }
    with SST:
    84 N*m{ 857 kgf*cm , 62 ft.*lbf }

    NOTICE:
    1. Use a torque wrench with a fulcrum length of 318 mm (12.52 in.).
    2. This torque value is effective when SST is parallel to a torque wrench.

  1. Remove the generator assembly from SST.

  1. Check that the clutch pulley rotates smoothly.

  1. Install a new clutch pulley cap onto the clutch pulley.

← INSPECTION (from Nov 2006)INSTALLATION (from Nov 2006) →