REASSEMBLY
Removal / installation · Vehicles built from Nov 2005
| 1.
INSTALL RING PIN |
 |
Using a plastic-faced hammer, tap in 2 new ring pins to the specified protrusion height.
- Protrusion height:
- 4.5 mm (0.177 in.)
| 2.
INSTALL STUD BOLT |
 |
Install the 6 stud bolts in the positions shown in the illustration.
-
Torque:
- Bolt A:
- 10 N*m{
102 kgf*cm
, 7.4 in.*lbf
}
- Bolt B:
- 22 N*m{
224 kgf*cm
, 16 in.*lbf
}


| 3.
INSTALL WITH HEAD TAPER SCREW PLUG NO. 1 |
 |
Install a new gasket onto the plug.
Using a 6 mm socket hexagon wrench, install taper screw plug No. 1.
-
Torque:
- 25 N*m{
255 kgf*cm
, 18 ft.*lbf
}
| 4.
INSTALL VALVE ROCKER ARM PIVOT |
 |
Install the valve rocker arm pivot onto the cylinder head.
-
Torque:
- 30 N*m{
306 kgf*cm
, 22 ft.*lbf
}
| 5.
INSTALL VALVE SPRING SEAT PLATE WASHER |
 |
Install the valve spring seat plate washer onto the cylinder head.
| 6.
INSTALL VALVE STEM OIL O SEAL OR RING |
 |
Apply a light coat of engine oil to the lip of a new valve stem oil seal.
| 7.
INSTALL INTAKE VALVE |
 |
Install the intake valve, outer compression spring and valve spring retainer onto the cylinder head.
Using SST, install the valve spring retainer lock.
- SST
- 09202-70020
- Using a plastic-faced hammer, lightly tap the valve stem tip to ensure that it fits properly.
- NOTICE:
- Do not damage the tip of the valve stem.
Apply a light coat of engine oil to the valve stem cap.
| 8.
INSTALL EXHAUST VALVE |
 |
Install the exhaust valve, outer compression spring and valve spring retainer onto the cylinder head.
Using SST , install the valve spring retainer lock.
- SST
- 09202-70020
- Using a plastic-faced hammer, lightly tap the valve stem tip to ensure that it fits properly.
- NOTICE:
- Do not damage the tip of the valve stem.
Apply a light coat of engine oil to the valve stem cap.