2005-2008 Yaris · Service Manual BODY ELECTRICAL

Back Door Entry Lock and Unlock Functions do not Operate

Circuit diagnosis · Vehicles built from Aug 2005

DESCRIPTION

When neither the door lock nor the door unlock function is operated from a particular door, the door electrical key oscillator (back door) of that door may not transmit request signals or the power door lock system may be malfunctioning.

WIRING DIAGRAM

B127994E01

INSPECTION PROCEDURE


1. CHECK DTC OUTPUT
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. By following the tester screen display, check whether any DTCs are output.

    OK:
    No DTC output.



NG
GO TO DIAGNOSTIC TROUBLE CODE CHART
OK


2. CHECK MANUAL DOOR LOCK AND UNLOCK OPERATION
  1. Check that the manual door lock and unlock functions operate normally.

    OK:
    Manual door lock and unlock functions operate normally.



NG
GO TO POWER DOOR LOCK CONTROL SYSTEM (ONLY BACK DOOR LOCK / UNLOCK FUNCTIONS DO NOT OPERATE)
OK


3. CHECK WIRELESS DOOR LOCK AND UNLOCK OPERATION
  1. Check that the wireless door lock and unlock functions operate normally.

    OK:
    Wireless door lock and unlock functions operates normally.



NG
GO TO WIRELESS DOOR LOCK CONTROL SYSTEM (W/ ENTRY AND START SYSTEM)
OK


4. PERFORM ACTIVE TEST BY INTELLIGENT TESTER (DOOR ELECTRICAL KEY OSCILLATOR (BACK DOOR))
  1. Select the Active Test, use the intelligent tester to generate a control command, and then check that the door electrical key oscillator (back door) operates.

    Certification ECU assembly:
    Item
    Vehicle Condition/Test Details
    Bdoor Transmttr
    Door electrical key oscillator (back door) ON/OFF

  1. B112461E08
    Measure the frequency.

    Standard:
    Tester Connection
    Condition
    Specified Condition
    D60-32 (CG8B) - D60-31 (CLG8)
    During ACTIVE TEST
    Frequency is generated (higher than 0 Hz)



NG
REPLACE DOOR ELECTRICAL KEY OSCILLATOR (BACK DOOR)
OK


5. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU ASSEMBLY - DOOR ELECTRICAL KEY OSCILLATOR)

  1. B128279E02
    Disconnect the D60 ECU connector.

  1. Disconnect the J37 oscillator connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    D60-31 (CLG8) - J37-1 (CLG5)
    Below 1 Ω
    D60-32 (CG8B) - J37-2 (CLGB)
    Below 1 Ω
    D60-31 (CLG8) or J37-1 (CLG5) - Body ground
    10 kΩ or higher
    D60-32 (CG8B) or J37-2 (CLGB) - Body ground
    10 kΩ or higher

  1. Reconnect the oscillator connector.

  1. Reconnect the ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


6. CHECK OPERATION OF DOOR ELECTRICAL KEY OSCILLATOR (BACK DOOR)
  1. After the door electrical key oscillator (back door) has been replaced with a normally functioning or a new one, check that the entry lock and unlock functions operate normally within the door electrical key oscillator (back door) detection area.

    OK:
    Entry lock and unlock functions operate normally.



NG
REPLACE MAIN BODY ECU
OK

END (DOOR ELECTRICAL KEY OSCILLATOR (BACK DOOR) IS DEFECTIVE)


← Back Door Entry Unlock Function does not Operate (from Aug 2005)Back Door Entry Lock Function does not Operate (from Aug 2005) →