2005-2008 Yaris · Service Manual TRANSMISSION

INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT SYNCHRONIZER RING NO. 3

C067848
  1. Check for any wear or damage.

  1. Apply gear oil to the 5th gear cone. Press synchronizer ring No. 3 against the 5th gear cone and check that synchronizer ring No. 3 does not turn in the directions shown in the illustration.
    If it turns, replace the synchronizer ring.

  1. C067850
    Using a feeler gauge, check the clearance between synchronizer ring No. 3 and the 5th gear with the synchronizer ring No. 3 in contact with to the cone of the 5th gear.

    Standard clearance:
    0.75 to 1.65 mm (0.0295 to 0.0650 in.)

    Minimum clearance:
    0.75 mm (0.0295 in.)

    If the clearance is less than the minimum, replace synchronizer ring No. 3.


INSPECT TRANSMISSION HUB SLEEVE NO. 3

C067978
  1. Check the sliding condition between transmission hub sleeve No. 3 and transmission clutch hub No. 3.

  1. Check that the edges of the transmission hub sleeve No. 3 spline rear are not worn down.

  1. C080375E01
    Using vernier calipers, measure the width of the transmission hub sleeve No. 3 groove (A) and the thickness of the claw part on gear shift fork No. 3 (B), and calculate the clearance.

    Standard clearance (A-B):
    0.3 to 0.5 mm (0.012 to 0.020 in.)

    If the clearance exceeds the standard, replace transmission hub sleeve No. 3 and gear shift fork No. 3.


INSPECT 5TH GEAR

C067975
  1. Using a caliper gauge, inspect the 5th gear as shown in the illustration.

    Standard inside diameter:
    29.915 to 29.931 mm (1.1778 to 1.1784 in.)

    Maximum inside diameter:
    29.931 mm (1.1784 in.)

    If the inside diameter exceeds the maximum, replace the 5th gear.


INSPECT REVERSE IDLER GEAR SUB-ASSEMBLY

C067846
  1. Using a caliper gauge, inspect the reverse idler gear.

    Standard inside diameter:
    18.040 to 18.058 mm (0.7102 to 0.7109 in.)

    Maximum inside diameter:
    18.058 mm (0.7109 in.)

    If the inside diameter exceeds the maximum, replace the reverse idler gear.

  1. Using a micrometer, inspect the reverse idler gear shaft.

    Standard outer diameter:
    17.966 to 17.984 mm (0.7073 to 0.7080 in.)

    Minimum outer diameter:
    17.966 mm (0.7073 in.)

    If the outer diameter is less than the minimum, replace the reverse idler gear shaft.

← DISASSEMBLY (from Nov 2005)REASSEMBLY (from Nov 2005) →