2005-2008 Yaris · Service Manual BRAKE

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Aug 2005

HINT:
The intelligent tester can be used in steps 3, 5 and 6.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
      NEXT

      3.DTCS AND FREEZE FRAME DATA CHECK AND CLEARANCE
        NEXT

        4.PROBLEM SYMPTOM CONFIRMATION
          Result
          Proceed to
          Symptom does not occur
          A
          Symptom occurs
          B

        B.
        A

        5.CAN COMMUNICATION SYSTEM CHECK
        1. Check for the output DTC relating to the CAN communication system.

          HINT:
          The ECU of this system is connected to the CAN communication system. Therefore, before starting +troubleshooting, be sure to check that there is no trouble in the CAN communication system.

          Result
          Proceed to
          CAN communication system DTC not output
          A
          CAN communication system DTC output
          B


        B.
        A

        6.DTC CHECK

          HINT:
          Click here.

          Result
          Proceed to
          DTC output
          A
          DTC not output
          B

        B.
        A

        7.DTC CHART

          HINT:
          Click here.

        NEXT

        8.CIRCUIT INSPECTION

          HINT:
          When 2 or more DTCs are detected, perform circuit inspections one by one until the problem is identified.

        NEXT

        9.PROBLEM IDENTIFICATION
          NEXT

          10.REPAIR OR REPLACEMENT
            NEXT

            11.CONFIRMATION TEST
              NEXT

              ← SYSTEM DESCRIPTION (from Aug 2005)CHECK FOR INTERMITTENT PROBLEMS (from Aug 2005) →