C1515/15 Torque Sensor Zero Point Adjustment is not Initialized
Diagnostic trouble codes · Vehicles built from Aug 2005
DESCRIPTION
This DTC does not indicate a malfunction. The power steering ECU outputs this DTC when it determines that the torque sensor zero point calibration has not been performed.| DTC No. |
DTC Detection Condition |
Trouble Area |
| C1515/15 |
Torque sensor zero point calibration not performed. |
|
INSPECTION PROCEDURE
| 1. PERFORM ZERO POINT CALIBRATION (TORQUE SENSOR) |
Perform torque sensor zero point calibration (Click here ).
| NEXT | |
| 2. CONFIRM DTC |
Check for DTCs.
Result: DTC still output even after performing torque sensor zero point calibration 3 times.
A
DTC still output even after performing torque sensor zero point calibration once or twice.
B
Normal system code output.
C
- HINT:
- The steering column assembly must be replaced if C1515/15 is still output even after the torque sensor zero point calibration is performed 3 times.
|
|
||||
|
|
||||
| A | ||
| ||
