2005-2008 Yaris · Service Manual STEERING

C1516/16 Torque Sensor Zero Point Adjustment Incomplete

Diagnostic trouble codes · Vehicles built from Aug 2005

DESCRIPTION

This DTC does not indicate a malfunction. The power steering ECU outputs this DTC when it determines that the torque sensor zero point calibration has not been completed successfully.
DTC No.
DTC Detection Condition
Trouble Area
C1516/16
Torque sensor zero point calibration not completed successfully.
  1. Torque sensor zero point calibration failure
  2. Steering column assembly

INSPECTION PROCEDURE


1. CLEAR DTC

NEXT


2. PERFORM INITIALIZATION (TORQUE SENSOR ZERO POINT)
  1. Perform initialization (Click here ).


NEXT


3. PERFORM ZERO POINT CALIBRATION (TORQUE SENSOR)
  1. Perform torque sensor zero point calibration (Click here ).


NEXT


4. CONFIRM DTC
  1. Check for DTCs.

    Result: 
    DTC still output even after performing torque sensor zero point calibration 3 times.
    A
    DTC still output even after performing torque sensor zero point calibration once or twice.
    B
    Normal system code output.
    C

    HINT:
    The steering column assembly must be replaced if C1516/16 is still output even after the torque sensor zero point calibration is performed 3 times.



B
Go to step 1

C
END
A

REPLACE STEERING COLUMN ASSEMBLY


← C1515/15 Torque Sensor Zero Point Adjustment is not Initialized (from Aug 2005)C1524/24 Motor Circuit Malfunction (from Aug 2005) →