P0182 Fuel Temperature Sensor "A" Circuit Low Input
Diagnostic trouble codes · Vehicles built from Nov 2005
Also covers:
- P0183 Fuel Temperature Sensor "A" Circuit High Input
DESCRIPTION
The fuel temperature sensor monitors the fuel temperature. A thermistor built into the sensor changes the resistance value according to the fuel temperature. The lower the fuel temperature is, the greater the thermistor resistance becomes, and the higher the temperature is, the lower the resistance becomes (see figure 1).The fuel temperature sensor is connected to the ECM. The 5 V power source voltage in the ECM is applied to the fuel temperature sensor from terminal THF via resistor R. Resistor R and the fuel temperature sensor are connected in series. When the resistance value of the fuel temperature sensor changes in accordance with the fuel temperature, the voltage at terminal THF also changes. Based on this signal, the ECM corrects the pressure control compensation of the supply pump and errors


- HINT:
- When the fuel temperature sensor output is outside the normal range, the ECM determines this as a malfunction.
| DTC No. |
DTC Detection Conditions |
Trouble Areas |
| P0182 P0183 |
Open or short in fuel temperature sensor circuit for 2.0 seconds (The MIL is illuminated and a DTC is immediately set when a malfunction is detected) |
|
- HINT:
- These DTCs are set when the engine idles for approximately 15 seconds.
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- Read freeze frame data using an intelligent tester. Freeze frame data record the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.
| 1. INSPECT FUEL TEMPERATURE SENSOR |
Disconnect the C63 fuel temperature sensor connector.

Measure the resistance.
- Standard resistance:
Tester Connections
Specified Conditions
1 - 2
13.92 to 17.01 Ω at -20°C (-4°F)
5.31 to 6.49 Ω at 0°C (32°F)
2.25 to 2.75 Ω at 20°C (68°F)
1.06 to 1.29 Ω at 40°C (104°F)
0.54 to 0.66 Ω at 60°C (140°F)
0.29 to 0.36 Ω at 80°C (176°F)
0.17 to 0.20 Ω at 100°C (212°F)
- OK:
- The fuel temperature sensor resistance is within the standard range.
Reconnect the fuel temperature sensor connector.
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (FUEL TEMPERATURE SENSOR - ECM) |
Disconnect the C63 fuel temperature sensor connector.

Disconnect the C50 ECM connector.
Check the resistance.
- Standard resistance (Check for open):
Tester Connections
Specified Conditions
THF (C50-39) - THF (C63-1)
Below 1 Ω
ETHF (C50-18) - E2 (C63-2)
- Standard resistance (Check for short):
Tester Connections
Specified Conditions
THF (C50-39) or THF (C63-1) - Body ground
10 kΩ or higher
ETHF (C50-18) or E2 (C63-2) - Body ground
Reconnect the fuel temperature sensor connector.
Reconnect the ECM connector.
|
|
||||
| OK | ||
| ||
