2005-2008 Yaris · Service Manual ENGINE

P0046 Turbocharger / Supercharger Boost Control Solenoid Circuit Range / Performance

Diagnostic trouble codes · Vehicles built from Nov 2005

Also covers:

DESCRIPTION

DTC No.
DTC Detection Conditions
Trouble Areas
P0046
P0605
P1633
ECM internal error
(The MIL is illuminated and a DTC is immediately set when a malfunction is detected)
  1. ECM

HINT:
These DTCs are set when the ignition switch is in the on (IG) position.


INSPECTION PROCEDURE

Read freeze frame data using an intelligent tester. Freeze frame data record the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.

1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0046, P0605 OR P1633)
  1. Connect an intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester on.

  1. Select the following menu items: Powertrain / Engine and ECT / DTC.

  1. Read DTCs.

    Result:
    Display (DTC output)
    Proceed To
    P0046, P0605 or P1633
    A
    P0046, P0605 or P1633 and other DTCs
    B



B
GO TO DTC CHART
A

REPLACE ECM


← P0045 Turbocharger / Supercharger Boost Control Solenoid Circuit / Open (from Nov 2005)P0089 Pressure Control Valve Plausibility to Consume Current High Intensity (+ P1271) (from Nov 2005) →