2005-2008 Yaris · Service Manual ENGINE

P1121 Accelerator Pedal Position Sensor Range / Performance Problem

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

Refer to DTC P1120 (Click here).
DTC No.
DTC Detection Conditions
Trouble Areas
P1121
Condition (a) continues for 0.5 seconds or more:
(a) VPA1 - VPA2 + 0.8 V > 0.35 V
(The MIL is illuminated and a DTC is immediately set when a malfunction is detected)
  1. Accelerator pedal position sensor

HINT:
This DTC is set when the engine idles for approximately 60 seconds.


WIRING DIAGRAM

Refer to DTC P1120 (Click here).

INSPECTION PROCEDURE

HINT:
Read freeze frame data using an intelligent tester. Freeze frame data record the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.


1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P1121)
  1. Connect an intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester on.

  1. Select the following menu items: Powertrain / Engine and ECT / DTC.

  1. Read DTCs.

    Result:
    Display (DTC Output)
    Proceed To
    P1121
    A
    P1121 and other DTCs
    B

    HINT:
    If any DTCs other than P1121 are output, troubleshoot those DTCs first.



B
GO TO DTC CHART
A

REPLACE ACCELERATOR PEDAL ASSEMBLY (ACCELERATOR PEDAL POSITION SENSOR)


← P1120 Accelerator Pedal Position Sensor Circuit Malfunction (from Nov 2005)P1229 Fuel Pump System (+ P1272) (from Nov 2005) →