2005-2008 Yaris · Service Manual ENGINE

P0704 Clutch Switch Input Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

The clutch switch is mounted on the clutch pedal. The switch is turned OFF when depressing the clutch pedal, and transmits a signal to the ECM.
DTC No.
DTC Detection Conditions
Trouble Areas
P0704
No clutch switch signals to ECM despite gears being shifted
(The MIL is illuminated and a DTC is set when the same malfunction is detected on 2 consecutive trips*
*: One trip is counted when the ignition switch is turned from off to on (IG) and back to off)
  1. Open or short in clutch switch circuit
  2. Clutch switch
  3. ECM

HINT:
DTC P0704 is set when the gears are shifted more than 10 times.


WIRING DIAGRAM

A115988E01

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (CLUTCH UPPER SWITCH)
  1. Connect an intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester on.

  1. Select the following menu items: Powertrain / Engine and ECT / Data List / Clutch Upper Switch.

  1. Read the value displayed on the tester.

    OK:
    Clutch Pedal Operations
    Specified Conditions
    Depressed by 22 mm (0.87 in.) or more
    ON
    Released
    OFF



OK
CHECK FOR INTERMITTENT PROBLEMS
NG


2. INSPECT CLUTCH SWITCH ASSEMBLY

  1. A129222E03
    Remove the A48 clutch switch.

  1. Check the resistance.

    Standard resistance:
    Switch Positions
    Specified Conditions
    Pushed in
    Below 1 Ω
    Released
    10 Ω or higher

  1. Reinstall the clutch switch.



NG
REPLACE CLUTCH SWITCH ASSEMBLY
OK


3. CHECK HARNESS AND CONNECTOR (CLUTCH SWITCH - ECM)

  1. A122672E01
    Disconnect the A48 clutch switch connector.

  1. Disconnect the A49 ECM connector.

  1. Check the resistance.

    Standard resistance (Check for open):
    Tester Connections
    Specified Conditions
    CLSW (A49-69) - Clutch switch (A48-2)
    Below 1 Ω

    Standard resistance (Check for short):
    Tester Connections
    Specified Conditions
    CLSW (A49-69) or Clutch switch (A48-2) - Body ground
    10 kΩ or higher

  1. Reconnect the clutch switch connector.

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM


← P0698 Sensor Reference Voltage "C" Circuit Low (+ P0699) (from Nov 2005)P1120 Accelerator Pedal Position Sensor Circuit Malfunction (from Nov 2005) →