2005-2008 Yaris · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. REMOVE MAGNET STARTER SWITCH ASSEMBLY

  1. A127302
    Remove the nut and the washer, and disconnect the lead wire from the magnet starter switch.

  1. A127303
    Using a torx socket wrench (T25), remove the 3 screws holding the magnet starter switch onto the starter drive housing.

  1. Remove the magnet starter switch.

  1. Remove the return spring.

  1. A127304E01
    Remove the plunger from the pinion drive lever.


2. REMOVE STARTER YOKE ASSEMBLY

  1. A127305
    Remove the 2 bolts and the starter yoke from the starter drive housing.


3. REMOVE STARTER BRUSH HOLDER ASSEMBLY

  1. A127306
    Hold the starter yoke in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. Remove the 2 screws and starter commutator end frame cover from the starter commutator end frame.

  1. A127307E01
    Remove the slotted washer.

  1. A127308E01
    Remove the washer.

  1. Remove the starter commutator end frame from the starter yoke.

  1. A104844E02
    Remove the starter brush holder from the starter armature.

    NOTICE:
    Do not pull on the rubber.


4. REMOVE STARTER ARMATURE ASSEMBLY

  1. A127309E01
    Remove the starter armature from the starter yoke.


5. REMOVE STARTER CLUTCH SUB-ASSEMBLY

  1. A127310E01
    Hold the starter armature assembly in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. Using a screwdriver, tap the inside stop collar toward the armature.

  1. A127311E01
    Using a screwdriver, pry off the snap ring.

  1. Pull the stop collar and starter clutch sub-assembly out of the armature.

← REMOVAL (from Nov 2005)INSPECTION (from Nov 2005) →