Removal / installation · Vehicles built from Nov 2005
1.
REMOVE VALVE LIFTER
Remove the 16 valve lifters.
HINT:
Keep the valve lifters in the correct order so that they can be returned to their original locations when reassembled.
2.
REMOVE INTAKE VALVE
Using SST, compress the inner compression spring and remove the 2 valve spring retainer locks, valve spring retainer, inner compression spring and intake valve.
SST
09202-70020
(09202-00010)
HINT:
Keep the intake valves, inner compression springs, valve spring retainers and valve spring retainer locks in the correct order so that they can be returned to their original locations when reassembled.
3.
REMOVE EXHAUST VALVE
Using SST, compress the inner compression spring and remove the 2 valve spring retainer locks, valve spring retainer, inner compression spring and exhaust valve.
SST
09202-70020
(09202-00010)
HINT:
Keep the exhaust valves, inner compression springs, valve spring retainers and valve spring retainer locks in the correct order so that they can be returned to their original locations when reassembled.
4.
REMOVE VALVE STEM OIL SEAL
Using needle-nose pliers, remove the valve stem oil seal.
5.
REMOVE VALVE SPRING SEAT
Using compressed air and a magnetic finger, remove the valve spring seat.
6.
REMOVE OIL CONTROL VALVE FILTER
Using an 8 mm hexagon wrench, remove taper screw plug No. 1, and then remove the gasket and oil control valve filter.