REASSEMBLY
Removal / installation · Vehicles built from Jan 2006
- CAUTION:
- Wear protective gloves. Sharp surfaces on the rear seatback frame could cause injuries to your hands.
| 1. INSTALL REAR SEATBACK LOCK ASSEMBLY |
w/ Cancel Function:

Install the rear seatback lock with the 2 bolts.
- Torque:
- 19.1 N*m{ 195 kgf*cm , 14 ft.*lbf }
w/o Cancel Function:

Install the rear seatback lock with the 2 bolts.
- Torque:
- 19.1 N*m{ 195 kgf*cm , 14 ft.*lbf }
| 2. INSTALL REAR SEATBACK FRAME SUB-ASSEMBLY |
Install the rear seatback frame.

Using hog ring pliers, install 8 new hog rings as shown in the illustration.

Install the rear seatback cover with the 6 clips.

| 3. INSTALL REAR SEATBACK STOP BUTTON GROMMET |
Engage the 2 claws and install the rear seatback stop button grommet.

| 4. INSTALL REAR SEAT HEADREST SUPPORT |
![]() ![]() |
- HINT:
- Use the same procedure for both sides.
Align the protruding portion of the front seat headrest support with the installation groove of the rear seatback frame.
Engage the 2 claws and install the rear seat headrest support.
| 5. INSTALL REAR SEATBACK LOCK CONTROL BEZEL (w/ Cancel Function) |
Engage the 2 claws and install the rear seatback lock control bezel.

| 6. INSTALL REAR SEATBACK LOCK RELEASE BUTTON |
Install the rear seatback lock release button.

| 7. INSTALL REAR SEAT SHOULDER BELT GUIDE |
Insert the pin into the rear seatback frame hole and install the rear seat shoulder belt guide with the 2 screws.

| 8. INSTALL REAR SEAT HEADREST ASSEMBLY |
Push the lock button of the rear seat headrest support and install the rear seat headrest.


