2005-2008 Yaris · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Jan 2006

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/ Front Seat Side Airbag) (Click here).

NOTICE:
Always use "Torx" socket wrench E10 when removing the front seat.

HINT:
The procedure described below is for the LHD. Use the same procedure for both the RHD and LHD, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working (w/ Front Seat Side Airbag).


2. REMOVE FRONT SEAT HEADREST ASSEMBLY

  1. B138314E01
    Push in the lock button of the front seat headrest support and remove the front seat headrest.


3. REMOVE FRONT SEAT ASSEMBLY

HINT:
Use the same procedure as for the driver side (Click here).


4. REMOVE RECLINING ADJUSTER RELEASE HANDLE

HINT:
Use the same procedure as for the driver side (Click here).


5. REMOVE FRONT SEAT CUSHION OUTER SHIELD

HINT:
Use the same procedure as for the driver side (Click here).


6. REMOVE FRONT SEAT INNER BELT ASSEMBLY

HINT:
Use the same procedure as for the driver side (Click here).


7. REMOVE FRONT SEAT CUSHION INNER SHIELD

HINT:
Use the same procedure as for the driver side (Click here).


8. REMOVE FRONT SEAT CUSHION COVER PAD (Built in Occupant Detection Sensor)

  1. B138331
    Disengage the 2 claws and remove the connector.

  1. Disengage the 2 claws and 7 hooks.

  1. B138627
    Using a clip remover, remove the 2 clips and the front seat cushion cover pad.

← COMPONENTS (from Jan 2006)INSPECTION (from Jan 2006) →