2005-2008 Yaris · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Nov 2006


1. INSTALL NO. 1 STRAIGHT SCREW PLUG

  1. A150950
    Using a 10 mm straight hexagon wrench, install 3 new gaskets and the 3 straight screw plugs.

    Torque:
    44 N*m{ 449 kgf*cm , 33 ft.*lbf }


2. INSTALL VALVE SPRING SEAT
  1. Install the valve spring seats onto the cylinder head.


3. INSTALL VALVE STEM OIL SEAL

  1. A146313E01
    Apply a light coat of engine oil to a new oil seal.

    NOTICE:
    Pay close attention when installing the intake and exhaust oil seals. For example, installing the intake oil seal onto the exhaust side or installing the exhaust oil seal onto the intake side can cause installation problems later.

    HINT:
    The intake valve oil seal is gray and the exhaust valve oil seal is black.

  1. A150956E01
    Using SST, push in the oil seal.
    SST
    09201-41020  

    NOTICE:
    Failure to use SST will cause the seal to be damaged or improperly seated.


4. INSTALL INTAKE VALVE

  1. A150955E01
    When installing the intake valves onto the cylinder head, check the marks on the end of the valve stem.

  1. A094935E04
    Sufficiently apply engine oil to the tip area of the intake valve shown in the illustration.

  1. Install the valve, compression spring and spring retainer onto the cylinder head.

    NOTICE:
    Install the same parts in the same combination onto the original locations.

  1. A150946E01
    Using SST and wooden blocks, compress the spring and install the 2 retainer locks.
    SST
    09202-70020   (09202-00010)

  1. A150974
    Using a plastic-faced hammer, lightly tap the valve stem tip to ensure a proper fit.

    NOTICE:
    1. Be careful not to damage the valve stem tip.
    2. Be careful not to damage the retainer.


5. INSTALL EXHAUST VALVE

  1. A150955E01
    When installing the exhaust valves onto the cylinder head, check the marks on the end of the valve stem.

  1. A094936E03
    Sufficiently apply engine oil to the tip area of the exhaust valve shown in the illustration.

  1. Install the valve, compression spring and spring retainer onto the cylinder head.

    NOTICE:
    Install the same parts in the same combination onto the original locations.

  1. A150947E01
    Using SST and wooden blocks, compress the spring and install the 2 retainer locks.
    SST
    09202-70020   (09202-00010)

  1. A150973
    Using a plastic-faced hammer, lightly tap the valve stem tip to ensure a proper fit.

    NOTICE:
    1. Be careful not to damage the valve stem tip.
    2. Be careful not to damage the retainer.


6. INSTALL VALVE STEM CAP

A150945
  1. Apply a light coat of engine oil to the valve stem caps.

  1. Install the 16 valve stem caps onto the cylinder head.

← REPLACEMENT (from Nov 2006)REPAIR (from Nov 2006) →