2005-2008 Yaris · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2006


1. DISCHARGE FUEL SYSTEM PRESSURE
(Click here)

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE NO. 2 CYLINDER HEAD COVER

  1. A163755
    Disengage the 2 fittings shown in the illustration.

  1. A163756
    Disengage the 2 fittings shown in the illustration, then remove the No. 2 cylinder head cover.


4. REMOVE NO. 2 VENTILATION HOSE

  1. A158237
    Remove the No. 2 ventilation hose.


5. SEPARATE ENGINE WIRE HARNESS

  1. A158238
    Remove the 3 bolts, harness clamp and 4 fuel injector connectors and separate the engine wire harness.


6. REMOVE HARNESS BRACKET

  1. A158239
    Disconnect the 4 wire harness clamps shown in the illustration.

  1. A158240
    Remove the 2 bolts and remove the 2 harness brackets.


7. DISCONNECT NO. 1 FUEL VAPOR FEED HOSE

  1. A158241
    Disconnect the No. 1 fuel vapor feed hose.


8. DISCONNECT VACUUM HOSE

  1. A158242
    Disconnect the vacuum hose.


9. REMOVE FUEL PIPE CLAMP

  1. A158243
    Remove the fuel pipe clamp.


10. DISCONNECT FUEL TUBE SUB-ASSEMBLY

  1. A158244E01
    Pinch the retainer of the fuel tube connector, then pull out the fuel tube connector to disconnect the fuel tube from the fuel pipe.

    NOTICE:
    1. Remove any dirt and foreign matter from the fuel tube connector before performing this work.
    1. Do not allow any scratches or foreign matter on the parts when disconnecting as the fuel tube connector has O-rings that seal the pipe.
    1. Perform this work by hand. Do not use any tools.
    1. Do not forcibly bend, twist or turn the nylon tube.
    1. Protect the disconnected parts by covering them with vinyl bags after disconnecting the fuel tube.
    1. If the fuel tube connector and pipe are stuck, push and pull to release them.


11. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

  1. A158245
    Remove the bolt.

  1. A158246
    Remove the 2 bolts and remove the fuel delivery pipe with the 4 fuel injectors.

    NOTICE:
    Do not drop the fuel injectors when removing the fuel delivery pipe.


12. REMOVE NO. 1 DELIVERY PIPE SPACER

  1. A158247
    Remove the 2 No. 1 delivery pipe spacers.


13. REMOVE INJECTOR VIBRATION INSULATOR

  1. A158248
    Remove the 4 injector vibration insulators.


14. REMOVE FUEL INJECTOR ASSEMBLY

  1. A158249E01
    Pull the 4 fuel injectors out of the fuel delivery pipe.

    NOTICE:
    Place the fuel injector in a plastic bag to prevent foreign matter from entering.

← COMPONENTS (from Nov 2006)INSPECTION (from Nov 2006) →